Quote:
Originally Posted by geoffretired  I assume by "back of the riser" you mean facing you as you shoot, therefore visible. Screw holes would not be allowed, nor would traces that showed where it used to be.I would guess that the whole of that section of the riser would need to be blank, in the sense that you could not identify any one part of it. |
I fear the worse in that respect then, there is a plastic strip which I think may have been added to the back. It runs from approx 2" above the sighting window to the bottom of the sighting window and is attached with two screws top and bottom. I was planning to remove this but it will leave the two screw holes and even if I fill them there will be evidence of where they were!
