| Great pics Sambow,
The problem is the same as the one I described earlier.
Pic 4 shows how low the body is that supports all of the arms you can use.
I would try raising the body on the up/down adjuster(pic 1) until the back end of the arms are nearly level with the shelf, then lower the angle on the prongs to bring the ends of the prongs down to where you want them.
Raising the body only becomes a problem if it is seriously higher than the shelf. At present it is well below that.Moving the whole rest back by one hole will obviously help a little too.From what I can see in the pics, it should drop almost flat out of the way when the different changes are made.
Do you shoot on the prongs with one fletch down through the gap? That would help clear the fletches past the screws that hold the prongs in place. |