ok. So the static measurement of 4mm as an example, at say a low brace height, should be re-adjusted if the BH is at max.
Limb bolt Pre load has the same effect on tiller measurement as BH. It changes what you see, if you change the setting. Your BH is abit like preload, The net result is your stressing your limbs more? so the relationship shows more...
But if the tiller of 4mm is a static measurement, then that relationship is set by the bolts. That relationship progresses though the shot cycle.
If that 4mm becomes 5mm with a higher BH then it will be more at full draw. And that is what is needed to achieve closer of the limbs equally? So if you stress your limbs more with a higher BH then that relationship should still be the same...
if you reset you tiller at the higher BH to be back to 4mm then that relationship would be 1mm out? closure is then not symetrical?
For example. If you have two cars, one is achiveing the 1/4 mile in 2 seconds less then the other that is fact and you cant change it, and you want them to reach the finish at the same time, The you need to make the track a little longer for the faster car, or shorter for the slower car...(tiller)
So all you have done is made the distance a variable now (BH/preload), and made the time the constant. acceleration is something you cant play with. In which case the track is now variable.
With the BH change you have changed the track length. The cars still have a 2second differece of 1/4 mile. and if you then say they still have a 2 second time difference over 1/8th mile...
NO they still have a 2 second time difference over 1/4 mile. its just now showing as 1 second over 1/8 mile. If you reset the track to 2 seconds over 1/4 mile the cars wont finish at the same time?
4mm at 7" is still 4mm at 7" if you wind you bolts in, it will show as say 5mm. or increase BH will show 5mm. or both will show 7mm. but thats still the same ratio of 4mm at the original setting?
need more beer
