[cliveanne]

Originally Posted by tel

What with everyone being so helpful yesterday..

Whilst shooting last night I had to tighten my long rod (ooh, err missus!) a couple of times, which isn't unknown. what was new though was the impression that I was actually turning the bush within the riser!
Firstly, anyone else had experience of this?
Secondly, assuming its a steel bush within a CNC machined aluminium riser, is there anything I can do about it?

TIA

tel

turning the bush within the riser!
Firstly, anyone else had experience of this?
Not unknown...... Is your riser under g'tee? if so get it back to 'em if not I would try a local engineering w/shop to see what can be done.