Quote:
Originally Posted by jthain  I had this problem that you are experiencing and found it really frustrating but managed to cure it with a bit of fiddling about.
On your jig is there two grub screws close together on the large collar that holds the rotating bit?. If so release the hexagonal screw that secures the rotating part and it comes out. I found that there were two positional collars inside, each has a ball bearing on a spring to push them into holes set into the collars that operate as you turn the rotating part but only one has a setting for three equally spaced holes for the ball bearing to fall into. I discarded the one with uneven settings and put back the one with the equally spaced settings and it worked fine.
Hope you understand this. |
Thanks John, I'll take a look inside.