sureloc scope holder keeps working loose.

[Fugue]

Originally Posted by CPlater1

I always tighten mine using an allen key. I get it finger tight, then twist slightly more. Always works well.

Ditto. Nice sight otherwise. I still blame it for me loosing my County Champs a few years ago when it first happened!

I still use it although I use the Shibuya Ultima on my other set up, which is another very nice sight.

[Apollo]

Had the same prob and more with this sight but i fixed it by using an old mushroom type limb saver with a cap screw through the middle and screwed into the bottom of the sight bar. This also stopped the main lock down screw from coming loose. Although this sight is old , it shows no wear in the windage adjustments which a few new sights would be very hard pressed to match.
Good shooting.

ps i still keep it as a back up

[not dead yet]

Originally Posted by sambow

I have recently replaced my Merlin Omega sight (which I had fitted with a 10/32 sight pin holder to hold a scope) with a Sureloc Challenger.

I am finding that half way through a shoot the main hand screw that holds the scope carrier to the vertical rack keeps working loose and my arrows start to rise by 6" (annoyingly It usually takes two sevens before I realise what happens!).This never happened once with my Omega (which used an allen bolt).

Has anyone else experienced this and are there any tips to prevent it happening.

got the surelok on my hoyt, its crap ,tightened the bolt with pliers and glued it too, due to the same thing happening.
have a toxonics on my switchbac, ten times better never rattles or anything