Hoyt Fuse Strings

[rohenwto]

Is any one using Hoyt Fuse string? I am having trouble finding D loop cord to lock on to what ever Hoyt are using for the centre serving, have tried BCY and Brownells to no avail, any ideas (Other than change the serving)

[hallso]

Hi, I put about an inch of serving, on top of the centre serving, above and below the nocking point then install the d-loop knots on top of that. It give the d-loop grip and it wont slip anywhere near as much.

[greydog]

Tie a little serving material above and below your nocking point, as hallso suggested, then put your D loop on. When it on, get an allen key, pass it through the D loop and pull the whole thing tight, this should help lock it down on the string, and the serving will stop it moving up.

[rohenwto]

Originally Posted by hallso

Hi, I put about an inch of serving, on top of the centre serving, above and below the nocking point then install the d-loop knots on top of that. It give the d-loop grip and it wont slip anywhere near as much.

Now, why didn't I think of that. Thanks.