|
14-07-06, 05:36 PM
| |||||
| |||||
| Pin nocks Is it possible to shoot a robin hood with pin nocks or will the pin prevent it becoming a robin hood ?
__________________ Tony      |
|
14-07-06, 09:41 PM
| |||||
| |||||
| Experience so far is that the pin prevents it. Usually the pin is a writeoff, but better that than the shaft.
__________________ If you make something idiot proof, all that happens is someone builds a better idiot. |
|
14-07-06, 10:23 PM
| |||||
| |||||
| I have heard the same, also if the pin does take a hit - change it as it wont take another! 
__________________ Purple Mafia  Luck is what you have left over after you give 100% |
|
14-07-06, 10:37 PM
| |||||
| |||||
| You have both confirmed what I already thought In that case well done Stace on your first almost robin hood shame it was my arrows you were shooting at the time 
__________________ Tony |
|
14-07-06, 10:44 PM
| |||||
| |||||
 already
__________________ Tony |
|
14-07-06, 11:39 PM
| |||||
| |||||
| If you hit the back of a pin nock and dent the pin, you can quite easily file out the dent and keep using the pin. I've done this for many of my arrows and never noticed a single bit of difference. The second or third time though... they don't hold up to multiple hits so well! |
|
15-07-06, 09:33 AM
| |||||
| |||||
| If you touch the pin at all, chances are its bent so bin it. If you hit the pin absolutely square on it drives down the shaft and its knackered. I have found beiter in out to be better and you dont have to mess about heating a pin to get it out of the shaft when you are out on a field course and getting short of arrows. |
|
15-07-06, 10:01 AM
| |||||
| |||||
| Think this should answer the question:  Peter |
|
15-07-06, 12:35 PM
| |||||
| |||||
| So should this, done with an ACE, pin nock and a recurve  dammit, images aint working.
__________________  |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
