|
10-03-07, 05:40 PM
| ||||
| ||||
| Beiter button barrel size Hey, does anyone know roughly what barrel length on a beiter button would be needed to fit an INNO riser?? Also, im assuming the INNO is standard imperial thread size?? Many thanks.      |
|
10-03-07, 06:20 PM
| |||||
| |||||
| most korean risers (assumming you are not using a wrap around rest) use the 17.5-23mm and the 5/16" thread |
|
10-03-07, 07:35 PM
| ||||
| ||||
| Many thanks I use a Spig Z/T rest so I guess the 21.5-27mm would be best to compensate for the rest? |
|
10-03-07, 08:07 PM
| |||||
| |||||
| Just make sure you go for a longer barrel length if you're using a wraparound rest,
__________________ Grumpy Cat says... No. |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
